const int IN1 = 3;
const int IN2 = 2;
int DoseT = 10;
int State = 0;
// the setup function runs once when you press reset or power the board
void setup() {
  // initialize digital pin 13 as an output.
  pinMode(0, OUTPUT);
  pinMode(IN1, OUTPUT);
  pinMode(IN2, OUTPUT);
  pinMode(DoseT, INPUT);
}

// the loop function runs over and over again forever
void loop() {
  State = digitalRead(DoseT);
  if (State == HIGH) {
  digitalWrite(IN1,HIGH);
  digitalWrite(IN2,LOW);
  digitalWrite(0, HIGH);   // turn the LED on (HIGH is the voltage level)
  }
  else if (State == LOW); {
  digitalWrite(0, LOW);    // turn the LED off by making the voltage LOW
  digitalWrite(IN1, LOW);
  digitalWrite(IN2, HIGH);
  }
}